DeLonghi P60 Notice D'emploi page 33

Installation advice
4
4
IMPORTANT
The appliance should be installed by a QUALIFIED INSTAL-
LATION TECHNICIAN.
Failure to comply with this condition will render the guaran-
tee invalid.
The appliance must be installed in compliance with regula-
tions in force.
Installation technicians must comply to current laws in force
concerning ventilation and the evacuation of exhaust gases.
Always unplug the appliance before carrying out any main-
tenance operations or repairs.
TECHNICAL INFORMATION FOR THE INSTALLER
In order to install the cooker top into the kitchen fixture, a hole with the dimensions
shown in fig. 4.1 has to be made, bearing in mind the following:
within the fixture, between the bottom side of the cooker top and the upper
surface of any other appliance or internal shelf there must be a clearance of
at least 30 mm. It is absolutely essential that you place a separator between
the base of the cooktop and the built-in unit or the oven;
the cooker top must be kept no less than 100 mm away from any side wall
(fig. 4.1).
the hob must be installed at least 60 mm from the wall.
there must be a distance of at least 650 mm between the hob and any wall
cupboard or extractor hood positioned immediately above (see fig. 4.2).
if the hob is installed over a built-in oven, there must be a distance of at least 30
mm between the two appliances.
INSTALLATION
COOKING HOBS with 4 ELECTRIC HOTPLATES
The appliance must be housed in heat-resistant units.
These tops are designed to be embedded into kitchen
fixtures measuring 600 mm in depth.
The walls of the units must not be higher than work top
and must be capable of resisting temperatures of 105
°C above room temperature.
Do not instal the appliance near inflammable materials
(eg. curtains).
Fig. 4.2
Fig. 4.1
33