Keysight U2741A Guide D'utilisation page 26

1 Getting Started
Table 1-1 SSI connector pin description (continued)
SSI timing signal
CLK10M
STAR_TRIG
GA0,GA1,GA2
Chassis installation
The L-Mount kit is to be installed to your U2741A module.
The following instructions describe the simple procedure of installing the L-Mount
kit and your module in the chassis.
1 Unpack the L-Mount kit from the packaging.
2 Remove your U2741A module from the bumper casing.
3 Use a Phillips screwdriver to fasten the L-Mount kit to your U2741A module.
4 Insert your U2741A module into the U2781A chassis with the 55-pin
5 Once you have slotted in the module, tighten the screws of the L-Mount kit to
26
backplane connector positioned at the bottom of the module.
secure the connection.
Functionality
10 MHz clock source
Star trigger
Geographical address pin
Keysight U2741A User's Guide