Replacing The Strimmer/Cutting Strimmer Cord; Storage; Disposal - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

14.2 Replacing the strimmer/cutting strimmer cord

1.) The strimmer (50), is removed as described in the section Installing/
replacing the strimmer. Press the marking (see Fig. 5a), turn the cover and
remove one half of the casing (see Fig. 5b).
2.) Remove the spool bobbin (J) from the strimmer housing (see Fig. 5c).
3.) Remove any remaining cutting Strimmer cord.
4.) Double the new cutting Strimmer cord in the middle and hook the loop that
you have made into the recess on the spool bobbin (see Fig. 5d).
5.) Wind the Strimmer cord tightly in an anticlockwise direction. The spool
bobbin (J) separates the two halves of the cutting Strimmer cord (see Fig.
5d).
6.) Hook the last 15 cm of the two ends of the Strimmer cord into the opposite
Strimmer cord holders (J) (see Fig. 5e).
7.) Guide the two ends of the Strimmer cord through the metal lugs in the
strimmer housing (see Fig. 5e).
8.) Press the spool bobbin (J) into the strimmer housing (see Fig. 5e).
9.) Reconnect the two halves of the housing.
10.) Pull hard on the two ends of the Strimmer cord to free them from the
Strimmer cord holders (see Fig. 5f).
11.) Cut any excess Strimmer cord back to about 13 cm. This reduces the load
on the engine when starting and warming up.
12.) Refit the strimmer (see section "Installing/replacing the strimmer"). Skip
points 3–6 if you are replacing the entire strimmer.

14.3 Storage

If the machine will be stored longer than 30 days:
 Empty Tank completely, avoid fuel spillage.
 To remove all fuel from the carburettor, start the engine and leave it to run until it stops.
 Let the machine cool down.
 Remove and clean cutting tools.
 Fit the guards
 Clean the machine and dry
 Store in a dry, out of reach of children place, well packaged (protection against cuts)

14.4 Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact
your local authorities for information regarding the available disposal options. When you
buy at your local dealer for a replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
MAINTENANCE
42