Assembly - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

12

ASSEMBLY

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
12.1 Assembly
Round handle:
 Start by fitting the rubber ring (5a) on the boom (8).
 Attach the barrier bar (6) onto the rubber ring (5a)
from below.
 The pin (5b) on the barrier bar (6) must be pushed
into one of the two holes on the boom (8) to lock it
into place.
 Push the round handle (5) onto the rubber ring (5a)
provided on the boom (8).
 Insert the 4 mounting bolts (4) from above through
the round handle (5) and secure them with the 4
nuts in the barrier bar (6).
 Tighten the bolts (4).
Quick release mechanism:
 Hook in the carabiner and secure it with the red
strap on the quick release mechanism.
 Pull on the red strap if you have to release the
appliance quickly.
Carrying harness:
 Hook the carrying harness (58) into the carrying lug (3).
 Adjust the length of the carrying harness (58) to your size (3a-3i), that the carrying lug (3) is
at hip height when hooked in place.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
ASSEMBLY
33