Zipper Maschinen ZI-GPS182J Manuel D'utilisation page 31

 Before the start, after the failure or shock, be sure to check the device and make sure that it is
in good condition.
 Wear firm gloves when you use the brush cutter or if you install or remove the cutting blade.
TRIMMER:
 Never cutting: above hip height, on a ladder, on trees
 Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again. Avoid abnormal posture
 Trim always perpendicular to the slope, never up and down
 No other person shall remain within 15m!
 This distance also adhere to things!
 Use personal safety equipment: safety googles or face protection, safety helmet, safety shoes,
work wear when working with the machine
 Wear safety gloves when work with the trimmer and work or change on the cutting blades
 To prevent damage to the machine never grind but lift completely.
 Always cut diagonally to the slope. Do not mow on excessively steep gradients.
 Take extra care when walking backwards. You may stumble! Always work at a walking pace,
never run!
 Inspect the area to be cut before you begin work. Remove any foreign objects (such as stones).
Look out for foreign objects (such as stones) while you are working.
BRANCH SAW:
 Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again. Avoid abnormal posture
 Always start cutting with full chain speed
 Pruning only remove chain is running out of the cut.
 Do not remove the same the whole road, but they work piecemeal from the end of the branch in
the direction of strain.
 No other person shall remain within 15m!
 This distance also adhere to things!
 Be careful at the end of the cut. Change in weight can lead to accidents.
 Keep balance and be cautious of falling branches.
 Do not use the branch saw in the vicinity of cables, power or telephone lines..
 Hold when working with the branch saw a safety distance of 10m to aboveground live lines.
 Use personal safety equipment: safety googles or face protection, safety helmet, safety shoes,
work wear when working with the machine
 Wear safety gloves when work with the trimmer and work or change on the cutting blades
 To prevent damage to the machine never grind but lift completely.
 Never cut with the tip of the blades. It may cause kickback!
HEDGE TRIMMER:
 Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again. Avoid abnormal posture
 No other person shall remain within 15m!
 This distance also adhere to things!
 Not to pick up objects using
 Use personal safety equipment: safety googles or face protection, safety helmet, safety shoes,
work wear when working with the machine
 Wear safety gloves when work with the trimmer and work or change on the cutting blades
 Cutting always start with running blades
 Take care to do not touch the blades!
TRANSPORT NOTES:
 Switch off the engine
 Fit the blade guard
 Secure the machine
 Empty tank completely, avoid fuel spillage
 To avoid damage to the device never drag but always lift correctly.
STORAGE NOTES:
 Remove and clean thread head and cutter blade
 Fit the blade guard
 Clean the machine and dry
 Empty Tank completely, avoid fuel spillage
 Store in a dry, out of reach of children place, well packaged (protection against cuts)
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
SAFETY
31