Installing/Replacing The Strimmer - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

 The cutting Strimmer cord protective guard C must be fitted when working with the cutting
Strimmer cord. The cutting Strimmer cord protective guard C (pre-fitted on delivery) is fitted as
shown in Figure 2a.
 Ensure that the cutting Strimmer cord protective guard C is correctly clicked into place. There is a
blade A on the inside of the cutting Strimmer cord protective guard C .This is covered with a
safety cover B (see Fig. 2a.).
 Remove the safety cover B before starting work and replace it after finishing work.
 To remove the cutting Strimmer cord protective guard C from the protective guard, take a tool,
such as a screwdriver, to carefully remove the three mounting pins.
12.1.11

Installing/replacing the strimmer

 Fit/remove the strimmer as shown in Figure 2c.
 Find the hole in the drive plate, align it with the opposite hole and block it with the supplied Allen
key.
 Screw the strimmer anticlockwise onto the thread. CAUTION! Left-hand thread!
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
ASSEMBLY
36