Fitting The Boom; Removing The Boom; Swivelling The Hedge Trimmer; Mounting The Saw Chain And Blade - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

12.1.1 Fitting the boom

 Start by undoing the screw grip (7) on the boom (8) of the motor unit.
 Slide the tab on the front boom (23, 56, 51) onto the boom (8)
of the motor unit.
 Must properly inserted the red line be flush with the boom of the motor unit.
 If this is not possible, pull the starter pull cord to adjust the shaft.
Caution! Switch the on/off switch (2) to „0".
 Tighten the screw grip (7).

12.1.2 Removing the boom

 Undo the screw grip (7) and pull the front boom (23, 56, 51) out of the
boom (8) on the motor unit.

12.1.3 Swivelling the hedge trimmer

 Release the lock (18).
 Press the control lever (22) and swivel the hedge trimmer into the
desired position.
 Allow the control lever (22) o click into the recess in the base plate
(hedge trimmer) (21).

12.1.4 Mounting the saw chain and blade

 Wear protective gloves! There is a danger of injury from the sharp
cutting teeth.
 Pay close attention to the running direction of the saw chain on the
blade and at the base plate (pole pruner)
 Depending on wear, the blade can be turned.
 Undo the nut (36) using the open-ended spanner.
 Remove the sprocket cover (38).
 Lay the saw chain (31) over the blade (30) starting
at the tip.
 Now fit the blade (30) and saw chain (31).
 Lay the guide rail (41) over the blade guide (39)
while inserting the chain tensioner pin (45) in the
blade hole (40). At the same time, lay the saw
chain (31) over the chain sprocket (43).
 Now you can tighten the saw chain (31) (see
section "Tightening and checking the saw chain").
 Replace the sprocket cover (38) and tighten the nut
(36) gently.

12.1.5 Removing the saw chain

 You may have to loosen the saw chain (31) to
remove the blade (30) and the saw chain (31) (see
section "Tightening and checking the saw chain").
Follow these instructions in reverse order.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
N O T I C E
ASSEMBLY
34