Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14.1.3 Cleaning the strimmer/3-section cutting blade attachment
Remove stuck cuttings.
Keep the 3-section cutting blade sharp to facilitate your work.
14.1.4 Cleaning the air filter
Contaminated air filters reduce the engine performance due to low air
supply to the carburettor.
Regular inspection is essential. The air filter (I) must be inspected
after every 25 hours of operation and cleaned if necessary.
The air filter must be checked more frequently if the air is dusty.
1.) Remove the cover of the air filter housing (16).
2.) Remove the air filter (I).
3.) Clean the air filter (I) by tapping or blowing it out (with
compressed air).
4.) Assembly takes place in the reverse order.
14.1.5 Spark plug
1.) Pull off the spark plug connector (10).
2.) Unscrew the spark plug using the spark plug wrench
supplied.
3.) Assembly takes place in the reverse order.
Electrode gap = 0.6 mm (distance between the electrodes between which the ignition spark is
generated). Check the spark plug for contamination after the first 10 hours of operation and clean it
with a copper wire brush if required. Afterwards, service the spark plug after every 25 hours of
operation.
14.1.6 Carburettor
Carburetor adjustments should be carried out only by trained specialist personnel!
14.1.7 Adjusting the throttle cable
If the appliance no longer reaches maximum speed after a while and all
other causes as described in the "Troubleshooting" section have been
ruled out, this may mean that the throttle cable needs to be adjusted.
To adjust the throttle cable, screw in the screw (H) or the adjusting
screw (H1) as well as the lock nut (H2) correctly.
14.1.8 Lubricating the gears
To do this, undo the screw (D) to press the gear grease into the gear
housing.
After filling the gearbox, close the lubrication hole with the screw (D).
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
NOTICE
MAINTENANCE
41
Publicité
Table des Matières
