Hedge Trimmer; Pole Pruner - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

13.4 Hedge trimmer

 The double-sided cutter bar allows cutting in both directions or by using swinging movements
from one side to the other.
 For a vertical cut, move the hedge trimmer evenly forwards or up and down in an arc.
 For a horizontal cut, move the hedge trimmer in a scything motion along the edge of the hedge
so that cut branches fall to the ground. Remove thicker branches with a branch cutter.

13.5 Pole pruner

Pay attention to falling clippings.

Be aware of the danger of branches flying back.

Sawing off small branches:
 Place the stop (33) on the branch. This will
help you work more safely and quietly.
 Saw small branches (Ø 0–8 cm) from the top
down.
Sawing off larger branches:
 When sawing larger branches (Ø 8–25 cm), first make a
relief cut A. A relief cut also prevents peeling of the bark
on the main trunk.
 Saw from the top B to the bottom A.
Saw in sections:
 Trim long or thick branches before you make the final cut.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
WARNING
OPERATION
39