Maintenance; Cleaning; Cleaning The Pole Pruner; Cleaning The Hedge Trimmer - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

14

MAINTENANCE

Turn the machine off, disconnect the spark plug and let the machine cool
The machine does not require intense maintenance. However, to ensure a long lifespan, we strongly
recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists! Use original ZIPPER parts only!
Ware safety gloves if you are work on the cutting tool!
Damaged cutting tools may never be straightened or welded!
Only a properly maintained equipment may be a satisfactory tool. Care and maintenance deficiencies
can cause unpredictable accidents and injuries.
Repairs should be performed only by authorized service centers.
Improper operation may damage the equipment or endanger your safety.
Loose or lost screws, nuts, bolts
Damage of any part of the machine
Damage of cutting tools
Fuel tank of tightness
Machine cleaning
Lubricating the gears
Cleaning spark plug
Cleaning air filter

14.1 Cleaning

Clean the machine and the working attachment from soil, dust, grass, chips, and small twigs, etc.
Clean the machine housing with a wet cloth and a mild detergent.
Do not use cleaning agents or solvents; these could attack the plastic parts of the
machine!
Put on all coatless flats a thin coat of oil.

14.1.1 Cleaning the pole pruner

 Remove the sprocket cover (38).
 Remove the saw chain (31) from the blade (30) and clean the guide rail (41).
 Keep the saw chain (31) and check the tension; check the oil level and the oil supply.

14.1.2 Cleaning the hedge trimmer

 Check the hedge trimmer for loose screws on the cutter bar (20) and tighten these if necessary.
 Remove stuck cuttings.
 Maintain the cutter bar (20) using an oil spray or an oil can.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
down before performing any maintenance work!
Controls for the maintenance of the machine
www.Zipper-Maschinen.at
ATTENTION
NOTICE
Regularly prior to each operation
Regularly prior to each operation
Regularly prior to each operation
Regularly prior to each operation
Regularly after operation
Every 25 working hours
Every 25 working hours
Every 25 working hours
NOTICE
MAINTENANCE
40