Switch Off The Engine; Trimming / Mowing - Zipper Maschinen ZI-GPS182J Manuel D'utilisation

13.2.3 Switch off the engine

If you need to stop the appliance immediately, switch the ON-OFF switch (2) to „0".
In normal sequence release the throttle lever (9) and wait until the engine has slowed down to its
idling speed. Then switch the ON-OFF switch (2) to „0".

13.3 Trimming / mowing

 Swing the appliance in a scything motion (see Fig. 6a).
 Hold the cutting tool parallel to the ground and set the desired cutting height.
Low trimming with strimmer:
 Hold the appliance with a slight incline to the ground (see Fig. 6b). Always cut away from your
body. Never pull the appliance towards you.
Short mowing with strimmer:
 Short mowing removes all the vegetation right down to the ground. Angle the strimmer 30° to
the right. Set the handle to the desired position (see Fig. 6c).
Extending the cutting Strimmer cord:
 To lengthen the cutting Strimmer cord, rev the engine to full throttle and tap the strimmer on the
ground. The Strimmer cord extends automatically.
 The knife A on the cutting Strimmer cord protective guard C cuts the thread to the permissible
length (see Fig. 6d).
Jamming:
Immediately turn off the engine if the cutting tool becomes blocked. Remove all grass and scrub
from the appliance before restarting the appliance.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
OPERATION
38