In-Tone & Out-Tone (Master Access); Add Pet; Individual Pet Settings - Petsafe 1000 Série Manuel D'utilisation

In-Tone & Out-Tone (Master Access)
Optional audible alerts can easily be set for all programmed pets to let you know when they enter or exit with the In-Tone and Out-Tone settings .
The default factory setting for both In-Tone and Out-Tone is off, but these can easily be changed to one of 10 audible tones .
Note: Door Operational Mode must be set to Smart Mode for In-Tone and Out-Tone to work .
To Change In-Tone Or Out-Tone:
1 . From Main Menu select Setup > Pet Settings > Master Access .
Use right arrow key to select .
2 . Use down arrow key to highlight In-Tone or Out-Tone (whichever
one you want to change) . Use right arrow key to scroll through the ten
options to select desired audible tone (each tone will play when
selected) or to turn tone off . Press left arrow/back key to return to
Main Menu .

Add Pet

The Passport Intelligent Dog Door allows up to 20 pets to be programmed . Adding a pet is time sensitive . You will have 30 seconds to add a pet to
™
the system so make sure the Passport
Note: Only one Passport
programming .
To Add Pet:
1 . Go to Main Menu > Setup > Pet Settings > Add Pet.
2 . Hold the Passport Key 13 cm to 15 cm from center of main flap and
™
parallel to flap . Patiently hold key in this position and wait for it to
program during the 30 second countdown . DO NOT HOLD KEY
AGAINST FLAP . It is very important Passport
at least 13 cm to 15 cm from flap so the Dog Door will consistently
read key when worn by your dog . Patiently hold Passport
position and wait for it to program during the 30 second countdown .
3 . When the Passport
™
beeps and the rename pet text screen will appear . Pet 'X' (with 'X'
being the next available pet number) will be listed at the bottom of the
screen . You can leave the Pet Name as the default or you can rename
the pet .
4 . To rename pet, use arrow keys on 5-Button Navigation to scroll through
text entry screen to Clr (clear) . Press enter/select key on 5-Button
Navigation to clear name . Use arrow keys to select letters on the text
screen to type pet's name . Select the
complete the new name . Repeat these steps for each pet you want to add to the Dog Door .
The individual pet settings allow you to customise settings and access to the Dog Door . It is very useful if you have multiple pets which need different
access options or settings . The default individual pet setting is Master Access until changed . Also if you have a different setting programmed for an
individual pet, it overrides the Master Access settings for that specific pet . Door Operational Mode must be set to Smart Mode for the individual
pet settings to work (see "Door Operational Modes") .
To change access and settings for a specific pet, from Main Menu select Setup > Pet Settings . Use down arrow key to highlight desired pet,
then press right arrow key to select .
Under each individual pet menu you will find the following options:
Pet Access: Menu where you can change the Access Mode, Re-latch time,
In-Tone, and Out-Tone for an individual pet .
Rename Pet: Allows the default name assigned by the Dog Door to be
changed to actual Pet Name or allows name to be changed .
Relearn Pet: Allows Dog Door to keep a pet's programmed settings if for
some reason the pet has to be re-programmed (for example, if replacing
8
Key is nearby before adding pet .
™
Key can be programmed at a time . Any other Passport
™
Key is programmed
™
Key is successfully programmed, you will hear three
symbol on text screen to

INDIVIDUAL PET SETTINGS

Key accessories near the Dog Door will prevent proper
™
Key in this
™
www.petsafe.net
Example: