Reset Button; Replacement Parts And Accessories; Terms Of Use And Limitation Of Liability - Petsafe 1000 Série Manuel D'utilisation

Red light is flashing (double blink every 6 seconds)
ATTENTION screen: Replace Clock Battery
ATTENTION screen: Flap Held Open
ATTENTION screen: Flap Jammed
ATTENTION screen: FAILED . . . Pet ID Already Learned
ATTENTION screen: Drivetrain Failure - Call Customer Care
Computer Application and the Dog Door are not communicating
Dog Door does not turn on .

Reset Button

If a problem continues or if you still have issues after turning off your Dog Door, you may need to reset
your Dog Door . The Reset Button "reboots" your Dog Door while keeping your programmed settings . The
Reset Button is the small, pin-sized button located on the Control Panel above the USB Port . Use a small pin
or paper clip to access the Reset Button . Push and then release . After your Dog Door reboots, the startup
screen will appear and then return to Main Menu .

Replacement Parts and Accessories

Replacement parts or accessories for your Passport
Customer Care Centre .

Terms of Use and Limitation of Liability

1. Terms of Use
Use of this Product is subject to your acceptance without modification of the terms, conditions and notices contained herein . Use of this Product
implies acceptance of all such terms, conditions and notices . If you do not wish to accept these terms, conditions and notices, please return the
Product, unused, in its original packaging and at your own cost and risk to the relevant customer care centre together with proof of purchase for
a full refund .
2. Proper Use
This Product is designed for use with pets where training is desired . The specific temperament or size/weight of your pet may not be suitable
for this Product (please refer to this Installation Guide for details) . Radio Systems Corporation recommends that this Product is not used if your
pet is aggressive and accepts no liability for determining suitability in individual cases . If you are unsure whether this Product is appropriate for
your pet, please consult your veterinarian or certified trainer prior to use . Proper use includes, without limitation, reviewing the entire Operating
Guide and any specific Caution statements .
• Low battery indicator. Recharge lithium-ion battery.
• Replace Clock Battery (see "Install Clock Battery and Power Adaptor"
section of Installation Guide) .
• Check for any objects obstructing flap and clear. Next press enter key
so Dog Door will cycle and lock flap . When flap relocks successfully,
the Main Menu screen will appear .
• Check for any objects obstructing flap and clear. Next press enter
key so Dog Door will cycle through and lock flap . When flap relocks
successfully, the Main Menu screen will appear .
• Pet's Passport
to add the correct dog or Passport
Passport
• Internal mechanical failure. Contact our Customer Care Centre for
assistance .
• Make sure USB cable is plugged into Dog Door USB Port and USB
port on your computer with the USB icon showing on LCD Screen .
• Make sure Dog Door Computer Application software is installed.
• Check for any door Passport
Computer Application software updates and install (see "Connecting
Dog Door to Computer" and "Firmware Updates") .
• Check Power Adaptor is plugged into power connection and LED on
adapter is illuminated .
• Check Power Adaptor is plugged into outlet.
• If using the rechargeable lithium-ion battery, check battery is
connected and inserted correctly with nothing obstructing the Battery
Compartment . Also make sure battery is fully charged .
Intelligent Dog Door can be purchased by visiting www.petsafe.net or by contacting our
™
www.petsafe.net
™ Key is already programmed . Check you are trying
Key . Make sure no other pets or
™
™ Key accessories already programmed are nearby .
Intelligent Dog Door firmware and
™
Reset Button
15