Find The Best Stimulation Level For Your Pet; Reset The Receiver Collar - Petsafe BDT-433 Manuel D'utilisation

Find the Best Stimulation Level
Step
4
for Your Pet
Important: Always start at the lowest Stimulation Level and work your way up.
The Remote Trainer has 8 different Stimulation Levels. This allows you to choose the
Stimulation that is best for your pet.
Once you have placed the Receiver Collar on your pet, it is time to fi nd the Stimulation
Level that is best for him. This is called the Recognition Level.
A slight change in your pet's behaviour, such as looking around in curiosity, scratching
at his collar, or fl icking his ears, indicates the Recognition Level that is best for him.
Follow the steps below to fi nd your pet's Recognition Level:
1. Starting at Level 1 on the Intensity Dial, press the Upper Button continuously for 1
to 2 seconds.
2. If your pet shows no reaction, repeat the Stimulation Level several times before
moving up to the next level.
3. Repeat each Stimulation Level several times before moving to the next level.
4. Move up through the Stimulation Levels until your pet reliably responds to the
Stimulation.
5. If your pet continues to show no response at Level 8, check the fi t of the Receiver
Collar. If your pet has long or thick hair, replace the Contact Points with the longer
set. Then go back to #1 and repeat the process. If this still does not yield any results,
your pet's hair will need to be trimmed around the Contact Points.
If all of these steps have been done and your pet continues to show no reaction to the
Stimulation, see the "Test Light Instructions" section.
If after completing all of these steps your pet still does not indicate he is feeling the
Stimulation, please contact Customer Care Centre or visit our website at
www.petsafe.net.
_____________________________________________________________

Reset the Receiver Collar

Step
5
To reset the Receiver Collar to work with a new Remote Transmitter or to reprogram a
new Receiver Collar to work with your existing Remote Transmitter:
1. Turn the Receiver Collar off.
2. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
3. Continue to hold the On/Off button until the Receiver Indicator Light has turned off.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet from each
other before this occurs. Once the Receiver Indicator Light has fl ashed fi ve (5) times,
the Receiver Collar has been reset. If the Receiver Indicator Light does not fl ash 5
times, start again and repeat the process.
www.petsafe.net 9