Baby Lock A-LINE Serie Mode D'emploi page 49

1
2
4
•
•
1 2
(C)
(B)
4
3
7
48
All manuals and user guides at all-guides.com
3
(A)
5
6
• Buttonhole
Pattern selector:
1
Presser foot: Buttonhole foot
2
Thread tension: 1 - 5
3
Stitch length: 0.25 - 1
4
To adjust buttonhole stitch density:
Set the stitch length dial between 0.5 and 1.0 to
adjust the buttonhole stitch density.
1 Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the
buttonhole marking running toward you.
2
Move the slider (A) toward you so that the top
mark (C) on the slider meets the start mark (B).
Line up the markings on the foot with the top
mark on the fabric.
Note: The scale on the slider is engraved
in centimeters.
3 Set the pattern selector dial at "
forward until you reach the front marking of
your buttonhole.
Stop sewing at a left stitch with the needle out
of the fabric.
Set the pattern selector dial at "
4
Sew 5 stitches. Stop sewing at a right stitch
with the needle out of the fabric.
5 Set the pattern selector dial at "
Sew until you reach the back marking of the
buttonhole. Stop sewing at a right stitch with
the needle out of the fabric.
6
Set the pattern selector dial at "
Sew a few bartacks and raise the needle
from the fabric. Set the stitch length dial to
"0" and the pattern selector dial at straight
sewing. Sew a few locking stitches.
7 Remove the fabric from the machine and cut
the sewing thread. Insert a pin inside the
bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
". Sew
".
".
".