Publicité
Les langues disponibles
Les langues disponibles
phenomena. Regulations require the presence of a battery
switch on the charger outputs of the + and the - poles.
Precautions regarding lightning
In areas highly exposed to lightning, it may be advisable to
install a lightning arrestor upstream of the charger to
safeguard it against irreversible damage.
Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical
wall or partition as indicated herein.
It is imperative that there be a gap of 150mm around the
charger. The installer must ensure that the temperature of
the air at the input is lower than 65°C in extreme
operating conditions.
Measures should also be taken to allow for the evacuation
of hot air on either side of the charger.
It's strictly forbidden to put any device on or against the
charger.
The charger must not be installed near a heat source ; it
should be installed in a well-ventilated area. The charger's
air inlets and outlets must not be obstructed.
Attention hot surface : do not touch the charger
during and after its operation (burn hazard).
29
Publicité
