Preparing For Installation - Thitronik WiPro III Manuel D'installation

Installation manual for WiPro III

1.6 Preparing for installation

Make sure you have the tools and materials listed below:
- Cross-head screwdriver
- Voltmeter
- 8mm drill bit
- Insulating tape
- Ring terminals
- Shrink sleeve if necessary
- Cleaning agent or degreaser
Choose a suitable place for installing the central unit, the wireless magnetic contact(s)
and other accessories.
Accessories such as the wireless magnetic contacts, wireless gas alarm and
radio cable loop should be assigned prior to installation. (see 1.8)
1.7 Adjusting WiPro to the vehicle type
Open the casing of the central unit (A) by gently levering up the casing cover as shown
in Diagram 1 on Page 6.
Set the DIP switch (A) in Diagram 2, Page 6 according to Table 1. If your vehicle is
not on the list or older, connect it in the usual way (see universal connection diagram,
Page 11) and make sure that switches 1 – 4 are in the off
The settings must be made with the circuit de-energised. Make sure that neither
the 20-pin plug nor the plug for the Pro-finder are plugged in.
Table 1
Other types of vehicles can be found at www.thitronik-automotive.de/en/support/faqs/faq-wipro-iii.html
Vehicles from 2006
and later
Fiat Ducato
Citroen Jumper
Peugeot Boxer
Iveco Daily
Ford Transit
Mercedes Sprinter
VW Crafter
Renault Master
Opel Movano
Nissan Interstar
New Renault Master
VW T5
VW T5 Facelift
- Crimping pliers
- Cordless screwdriver
- Socket set
- Butt connectors
- Cable ties
- Cleaning cloth for degreasing
Years of Switch 1
manu-
facture
2006
off
and later
2006
on
and later
2006
on
and later
2006
on
to 2011
2011
off
and later
2006
on
to 2009
2010
on
and later
position.
Switch 2 Switch 3
on off
on off
off off
on on
on on
off on
off off
Page 4
GB
Switch 4
off
off
off
off
off
off
on