Installation Instructions - Thitronik WiPro III Manuel D'installation

Installation manual for WiPro III

1.2 Installation instructions

When working on the vehicle electrical system and there is a risk of a short
circuit, the minus pole of the battery must be disconnected. The minus pole
of additional supply batteries must also be disconnected.
Note! When the vehicle battery is disconnected, some of the data from the
vehicle electronic system will be lost. Make sure that you have the radio code
because this will have to be re-entered. Data such as the time are volatile and
must also be re-entered.
Parts which are mounted on the vehicle must be fastened down so they do not
come adrift due to vibrations, sudden braking or other conditions and block vehicle
functions such as the steering system and pedals etc.
Cables must be protected from wearing through or other mechanical stress by
using appropriate fasteners to secure them.
Whenever working on the vehicle, always follow the safety and working
instructions stipulated by the vehicle manufacturer and vehicle trade.
Please read this installation manual carefully to avoid problems during installation.
Incorrect installation can damage both the alarm system and the vehicle. If problems
occur during installation, we will be glad to assist you.
However, assistance is possible only if you have read and understood this manual
completely and if you are sufficiently qualified to install the system.
Specialist dealers can obtain vehicle-specific installation documents with precise
specifications for connecting the CAN bus, smart indicators, horn and central locking
system evaluation and much more on request. These contain the pin assignments on
the vehicle connectors and the position of the components.
1.3 Special features specific to the vehicle
General: All vehicle doors which are monitored by the vehicle computer require no
wireless magnetic contact, since these doors are automatically secured via the CAN
bus when the WiPro unit is properly connected to the vehicle system. This is also the
case with fully integrated vehicles in which the body manufacturer has connected the
door contacts of the basic vehicle.
This is the case if an opened door is displayed on the multi-purpose display.
For some vehicle types (e.g., Sprinter, T5, T6), the horn will only operate when the
ignition is on. The vehicle horn is not triggered by WiPro III in this case. It is
recommended to mount a siren in the engine compartment or to use a back-up siren.
Further information:
http://www.thitronik-automotive.de/en/support/faqs/faq-wipro-iii.html
Page 2
GB