Dometic PSB12-40 Instructions De Montage Et De Service page 19

9 Configuration
NOTICE! Damage hazard
Use a small screwdriver to carefully move the DIP switches to the required position.
Setting up the alternator type
This function can only be activated by the DIP switch, not by an external controller (optional DTB01 display or mobile
app).
Slide the DIP switch according to your vehicle alternator type.
Table 5: Alternator configuration
DIP switch position (gray)
Setting the charging program
NOTICE! Damage hazard
Only use batteries that are suitable for the specified charging voltage.
Select the charging program suitable or the type of house battery used based on the battery manufacturer's specifi-
cations, the information on the charging curves (see
data ). The specified charging times apply to an average ambient temperature of 20 °C.
Setting charging programm can be activated by the DIP switch on the charger or, if a Bluetooth N-BUS device is
present in the N-BUS network, via the DTB01 display or via the mobile app.
Function
Standard alternator
Smart alternator
Battery charging
activated
deactivated
activated
deactivated
function) and the technical data (see
EN
13.3 V
12.7 V
11.7 V
11.25 V
Technical
17