Dometic PSB12-40 Instructions De Montage Et De Service page 18

EN
2. Connect the fuse holder to the positive pole of the starter battery.
3. Connect the other end of the fuse holder to
4. Insert a fuse into the fuse holder.
5. Connect the fuse holder to the positive pole of the house battery .
6. Connect the other end of the fuse holder to
7. Insert the output fuse into the fuse holder.
8. Connect the D+ or ignition+ signal wire to PIN 1 of the terminal block.
9. Optional: Connect the output voltage control positive signal cable (+SENSE) from PIN 2 of the terminal block
to the positive pole of the house battery, and the negative signal cable (-SENSE) from PIN 3 of the terminal block
to the negative pole of the house, using a cable with 1 mm² cross-section. This connection will reduce the volt-
age drop on power cables during the charging process by an electronical control device.
10. Optional, only applicable to models PSB12-40, PSB12-80, PSB24-40, PSB24-60: Connect a device
AUX
to the connection, see connection diagram,
ant D, Connection variant
Connection variant A
Connection variant for basic installation with 12 V or 24 V batteries.
To connect the battery charger proceed as shown.
fig.  on page 3
Connection variant B
Connection variant for vehicles without control unit or with a split charge relay.
To connect the battery charger proceed as shown.
fig.  on page 4
Connection variant C
Connection variant for vehicles with control unit already installed.
To connect the battery charger proceed as shown.
fig.  on page 4
Connection variant D
Connection variant for a 24 V system for vehicles without control unit or with a split charge relay.
To connect the battery charger proceed as shown.
fig.  on page 5
Connection variant E
Connection variant for a 24 V system for vehicles with control unit already installed.
To connect the battery charger proceed as shown.
fig.  on page 5
16
INPUT
OUT
E.
.
.
Connection variant B, Connection variant C, Connection vari