Publicité
Les langues disponibles
Les langues disponibles
5.3 - MALFUNCTION SIGNALLINGS
DISPLAY
eme
eex
eLs
efO
RELAY 4
eeD
eph
RELAY 3
eth
fuL
err
NOTE - The visualization of an error on the display persists until the "DOWN" button is pressed or until another command is given.
WARNING - the restore from an EEx error must be carried out through one of the 3 buttons of the control unit (UP, MENU or DOWN).
WARNING! If the supply fuse blows with the motor blocked, check the intervention thresholds of the current sensor. A correct configuration of
the SEN and SEL parameters limits the possibility of failure of the power supply fuse. To avoid the intervention of the supply fuse in the condition of
motor block it is advisable to use the inversion function on the obstacle.
5.4 - SIGNALLING LED
RELAY 2
RELAY 1
+24VDC
OGL
GND
+24VDC
TX PHOTO
1-2: FLASH
3
4
5
6
7
LED
EDGE
PH2
PH1
STOP
OPEN
CLOSE
PED
SS
LS1
LS2
RADIO
POWER ON
8/20
All manuals and user guides at all-guides.com
DESCRIPTION
Memory error: the external memory not installed or not recognised.
Memory error during the writing: the value x is a number from 1 to 6. In the event of the error, contact the technical assistance.
Limit switches error: opening and closing limit switches are busy in the same time
Impact sensor intervention.
Safety edge intervention.
POWER
Malfunctioning of photocells.
Thermical intervention to preserve the control unit.
Full external memory.
Memory error during functions viewing memory location or cancellation of a single transmitter.
25
+
26
-
J5
ON
DIP-SWITCH
EDGE
PH2
PE
8
9
10
11
COLOUR
DESCRIPTION
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
RED
Led is turned on when the limit switch is not activated.
RED
Led is turned on when the limit switch is not activated.
RED
Led ON with a radio transmission or interferences.
GREEN
Led normally ON. It shows the presence of the power supply.
DISPLAY
ON
UP
DOWN
MENU
SS
PH1
STOP
OPEN CLOSE PED
SS
12
13
14
15
16
17
ITA
ENG
FRA
ESP
22
21
J3
J4
J2
RADIO
COM LS1
LS2
18
19
20
6-1622400 rev. 5
FIG. 5
04/06/2019
Publicité
