Publicité
Les langues disponibles
Les langues disponibles
BRITAX Child Safety, Inc.
Installing the Child Seat
General Information
Harness Mode
WARNING!
Install forward-facing only.
DO NOT use anything to raise the child seat off of the
vehicle seat.
DO NOT install with LUAS for a child weighing more
than 18 kg (40 lbs) in harness mode.
The top tether must be used at all times when
installing the child seat in harness mode. Using the
top tether will improve the stability of your child seat
and reduce the risk of injury.
•
Use this child seat in harness mode with children at
least 2 years of age and who weigh between 11.3 and
30 kg (25 and 65 lbs) and who stand between 85 and
125 cm (34 and 49 in.) in height. Britax recommends
using harness mode until your child outgrows its fit
requirements. See the Child Fit Information section on
page 7 for more information.
•
This seat may be used in either the upright or recline
position in harness mode (see figures at right).
Upright Position
8
Recline Position
GROW WITH YOU CLICKTIGHT / PLUS User Guide
Booster Mode
WARNING!
Position forward-facing only in a seating position with a
lap-shoulder belt.
Use only the vehicle's lap and shoulder belt system when
securing a child in booster mode. Never secure a child
with a lap belt only in booster mode.
Always secure the unoccupied child seat to the vehicle
by attaching the lower connectors to the lower anchors in
the vehicle, or by fastening the vehicle seatbelt across the
unoccupied child seat.
If the lower anchors in your vehicle prevent proper vehicle
belt fit across your child you cannot use LUAS to position
this seat in booster mode. See below.
The vehicle belt fits properly when the
vehicle shoulder belt lays straight across
the center of the child's chest, above the
child's shoulder and does not contact the
child's neck (A). The lap part of the vehicle
belt should be worn under the armrests
and rest low on the child's upper thighs (B).
•
This child seat can be used in booster mode with
children who weigh between 18 and 54 kg (40 and 120
lbs) and stand between 112 and 160 cm (44 and 63 in.)
in height. Britax recommends using booster mode only
once your child has outgrown harness mode.
•
This child seat cannot be
in the reclined position
when used in booster
mode.
•
In booster mode, this child
seat can be positioned
on the vehicle seat using
the LUAS system. Use the
vehicle's lap-shoulder belt
to secure the child. Ensure
that the LUAS system
does not interfere with the
vehicle belt function and
alignment when securing
your child.
9
Publicité
