Publicité
Les langues disponibles
Les langues disponibles
BRITAX Child Safety, Inc.
• Check that your vehicle has a top tether anchor. Do not use top
tether without securing lower connectors.
• Loosen the tether and place it over the back of the child seat to
keep it from becoming pinned between the child seat and vehicle
seat during positioning.
• Adjust the child seat to the upright position and place forward
facing on the vehicle seat.
1. Release the buckle and
open the CLICKTIGHT
to access the lower
connectors.
a. Locate the two slots
in the CLICKTIGHT
cover.
b. Squeeze the
CLICKTIGHT release
levers.
2. Route the lower connector
strap along the green belt
path.
3. Firmly attach the lower
connector onto their
adjacent lower anchors.
For push-on lower
connector only: A click
helps confirm attachment.
NOTE: Verify that the strap is
not twisted.
4. Pull the end of the lower
connector strap to remove
slack.
IMPORTANT:
Overtightening
the webbing may prevent the
CLICKTIGHT from properly
securing.
5. Close the CLICKTIGHT.
A click helps confirm the
CLICKTIGHT is secure.
6. Firmly press the tether
hook over a designated
vehicle tether anchor.
Remove slack.
7. Secure excess webbing
with the elastic strap.
16
Lower Connector
Lower Connector
Push-on
Hook
(Select Models)
Or
Or
GROW WITH YOU CLICKTIGHT / PLUS User Guide
Securing Your Child
Harness Mode
WARNING!
Never route the vehicle belt over the child when using
this child seat in harness mode.
Adjust the belts provided with this child seat so they
fit snugly around your child. A snug strap should not
allow any slack. It lies in a relatively straight line without
sagging. It does not press on the child's flesh or push
the child's body into an unnatural position.
Verify that the child seat is secure and the harness is
properly adjusted around the child each time the child
seat is used.
Before you begin:
Always check the seat area for debris and remove it to prevent
interference with the harness adjuster mechanism or CLICKTIGHT.
1. Loosen the harness.
a. Press the release lever.
b. Pull both harness straps
forward.
2. Open the chest clip.
a. Press tabs.
b. Pull apart.
3. Release the buckle and
place the harness straps
around the armrests.
4. Place the child in the
child seat. Ensure the
child is positioned upright
in the child seat and not
slouching. Their bottom
must touch the child seat,
and their back must rest flat
against the back of the child
seat.
17
Publicité
