Publicité
Les langues disponibles
Les langues disponibles
BRITAX Child Safety, Inc.
WARNING!
WARNING!
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised high
enough to properly adjust the harness
for the fit of your child. DO NOT force
the child seat head restraint. Doing
so could cause the child seat not to
perform as intended. If the location of
the vehicle head restraint interferes with the child seat
head restraint, raise or remove the vehicle head restraint.
If the vehicle head restraint cannot be removed, move
the child seat to the upright position or try a different
seating location.
Overhang
Harness Mode
It is important that the base of the child seat rests
completely flat on the vehicle seat with no side overhang.
As seen in the illustration. It is permissible to allow up to
7.6 cm (3 in) of the base to hang over the front edge of the
vehicle seat if the vehicle seat does not allow enough of the
child seat base to make contact, adjust the recline angle to
a more upright position. Not doing so could cause the child
seat to not perform as intended.
Booster Mode
Overhang is not allowed in booster mode. In booster mode,
the base of the child seat must fit completely on the vehicle
seat.
Harness Mode
7.6 cm
Adjusting Buckle Position
Removing the Buckle
1. Unbuckle the harness by
pressing the release button
and pulling the tongues.
22
Booster Mode
GROW WITH YOU CLICKTIGHT / PLUS User Guide
2. Open the CLICKTIGHT.
a. Locate the two slots
in the CLICKTIGHT
cover.
b. Squeeze the
CLICKTIGHT release
levers.
3. Unhook the elastic straps
at the back of the seat
cover.
For select covers only:
Unhook the retaining clips at
the back of the seat cover.
4. Pull the seat cover
forward and over the belly
pad.
5. Turn and pull the buckle
retainer through the slot in
the child seat shell.
Positioning the Buckle
Choose the slot closest to, but not under the
IMPORTANT:
child.
1. Turn and push the buckle
retainer through the slot in
the child seat shell.
2. Pull the EZ-Buckle belly pad
through the corresponding
slot in the seat cover.
3. Place the seat cover back in
its original position.
a. Attach the elastic strap.
b.
For select covers only:
Attach the retaining clips.
23
Publicité
