Hypertherm Powermax45 Mode D'emploi page 6

Plastic Base Replacement
Install the new plastic base and reassemble the power supply
1. Verify that the serial number on the old base matches the serial number on the new base.
Contact Hypertherm if the serial numbers do not match. The serial number can be found on the
data plate label.
2. Align the screw holes in the new plastic base with the screw holes in the magnetics assembly,
and install the 6 new screws that came with the kit.
3. Align the plastic base
magnetics assembly
the power supply center
panel . Make sure the wires
3
from the inductors and
transformer are routed
between the appropriate
guide pins
4
base. There are notches in
the center panel so the wires
do not get pinched. Once the
wires are in place and the
plastic base is properly
aligned, press the plastic
base into place.
4. Install the filter drain hose to
the drainage fitting on the
plastic base.
5. Replace the end panels
securing them with the
bottom retaining screws.
Make sure the screw hole in the ground clip on the top of the rear end panel aligns with the
screw holes in the end panel and the power supply center panel.
6. Being careful not to pinch any of the wires, replace the component barrier and slide the cover
back onto the power supply. Make sure the bottom edges are in the tracks. Position the handle
over the holes in the top of the cover, then use the 2 screws to secure the cover.
7. Reconnect the electrical power and the gas supply.
6
All manuals and user guides at all-guides.com
and
1
with
2
in the plastic
,
5
3
4
805830 Field Service Bulletin
5
2
1
Powermax45