Hypertherm Powermax45 Mode D'emploi page 4

Plastic Base Replacement
Remove the plastic base
Static electricity can damage circuit boards. Use proper precautions when handling
printed circuit boards.
Store PC boards in anti-static containers.
Wear a grounded wrist strap when handling PC boards.
1. Turn OFF (O) the power, disconnect the power cord, and disconnect the gas supply.
2. Remove the 2 screws from the handle on the top of the power supply. Remove the handle, and
lift the cover off of the power supply.
3. Remove the component barrier that protects the power board.
4. Disconnect the filter drain hose

Make sure you reconnect the filter drain hose when you reassemble
the unit.
1
4
All manuals and user guides at all-guides.com
NOTICE
from the drainage fitting on the plastic base.
1
805830 Field Service Bulletin Powermax45