Hypertherm Powermax45 Mode D'emploi page 5

5. Lay the power supply on its side or hold it upside down. Remove the retaining screws
the bottom of each end panel and pull the end panels slightly away from the power supply.
6. Place the wooden end of a swab, a stiff wire, or other similar tool about 2 mm (0.09 inch)
diameter into each of the 7 holes
one until the clips release and you can pull the plastic base and its attached components away
from the center panel.
7. Remove the 6 screws
discard them. Remove the plastic base and discard it.
2
Powermax45 Field Service Bulletin
All manuals and user guides at all-guides.com
on the power board side of the plastic base. Press each
3
from the plastic base that hold the magnetics assembly in place and
4
4
3
805830
Plastic Base Replacement
from
2
2
5