Philips HF3650 Mode D'emploi page 19

Problem
I do not hear the alarm
sound when the alarm
goes off.
The FM radio* does not
work.
The FM radio* produces a
crackling sound.
The alarm went off
yesterday, but it did not
go off today.
I wanted to snooze, but
the alarm did not go off
again after 9 minutes.
The light wakes me too
early.
Solution
Perhaps you set a sound level that is too low. To set a higher sound level,
increase the volume level of the wake-up sound in your wake-up profile.
When you have set an alarm, you will first see the light of the wake up curve.
The alarm sound only starts playing when the set alarm time is reached. You
can change the duration of the wake up light curve.
Perhaps you turned off the alarm function. The alarm icon is visible on the
display when the alarm function is active.
If you selected the FM radio* as the alarm sound, turn on the FM radio* after
you turn off the alarm to check if the FM radio* works.
Check if your FM radio* is correctly tuned to a radio station. If necessary, adjust
the frequency. If it does not work, contact the Consumer Care Center in your
country.
Perhaps you set the volume too low. Increase the volume level.
Check if your FM radio* is correctly tuned to a radio station. If necessary, adjust
the frequency.
Change the position of the antenna by moving it around. Make sure you have
unwound the antenna completely.
Contact the Consumer Care Center in your country.
Perhaps the broadcast signal is weak. Adjust the frequency and/or change the
position of the antenna by moving it around. Make sure you have unwound the
antenna completely.
Perhaps you turned off the alarm function. The alarm icon is visible on the
display when the alarm function is active.
Perhaps you set a volume level and/or light intensity level that is too low. Set a
higher volume and/or light intensity level in your wake-up profile.
When there has been a power failure, the clock time will keep on running up to
8 hours. Perhaps the power failure lasted longer. In this case, you have to set
the clock time again.
Tap on the top of the Sleep & Wake-Up Light to snooze. If you press the button
to dismiss the alarm, the alarm profile is deactivated for that day.
Perhaps the light intensity level you have set is not appropriate for you. Try a
lower light intensity level if you wake up too early. You can also change the
duration of the wake-up curve. If light intensity 1 is not low enough, move the
appliance further away from the bed.
English
19