Functional Test - Westfalia 300 052 391 102 Instructions De Montage

As illustrated in the wiring plan, all other wires are to be worn away at the respective vehicle wires
with cutter connectors.
You must ensure that the cutter connectors are installed by a qualified person. The wire connectors
should be locked away in the wires after the cutting. If the line cross section of the vehicle's lines are
not between 0.75 and 1.0 mm
Loading Plan:
Function Vehicle:
Left flash relay, switch
Left indicator, rear light
Brake light
Left tail lamp
Right flash relay, switch
Right indicator, rear light
Right tail lamp
Fog lamp, switch
Fog lamp, rear light
Earth
Continuous positive +12V
Additionally available on the 13 pin version:
Back light
Continuous positive

Functional test:

Re-connect the earth wire to the battery.
Check that the electronic installation is functioning properly. Use a trailer or a suitable testing
instrument with load resistance in order to test the electronic installation. The control unit may
malfunction if a testing instrument without load resistance is used.
The continuous plus extension set for the 13 pin electronic installation is available in specialist
shops under the Westfalia parts no. 300 025 300 113.
then different cutter connectors to those supplied should be used.
2
Cable Set Line Color:
yellow
green/white
black/red
grey/black
red / green
gray / yellow
gray / red
blue
gray
brown, brown/white
red, 10A secured
green
red
GB
Cross Section:
1.0
1.0
1.0
0.75
1.0
1.0
0.75
0.75
0.75
1.5 / 2.5
2 x 1.5
0.75
2,5
13