Westfalia 300 052 391 102 Instructions De Montage page 12

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB
Installing and Connecting the Control Unit
Depending on the type of vehicle, attach the control unit to the white 12-pin plug behind the
dashboard or side covering in front, using the supplied mushroom band.
Attach the earth wires brown 1.5 and brown/white 2.5 to a suitable earthing position.
Place the continuous positive wires red 1.5 mm² up to the battery, while ensuring that the wire
cannot be damaged by vehicle parts. If necessary, provide the wire with additional protection.
Lock the end of the continuous positive wire into place on the supplied fuse holder, locking the
supplied continuous positive connection piece into place in the second chamber of the fuse holder
and secure the fuse holders locked contacts with the supplied fuse clip. Connect the continuous
positive connection piece's ring eyelet to the battery's positive pole. Ensure that the fuse holder
has been perfectly attached.
Connection to the Vehicle's Wires
When connecting the indicator wires, the respective indicator wire has to be separated at the rear
light. Connect the wire ends with the enclosed terminal connector according to the wiring plan.
Please ensure that installation is carried out by a qualified person and that the cutting connector
has perfect contact with the respective wires.
yellow or red/green
indicator switch
Separate the supply line from the rear fog lamp at a suitable position, and connect the wire from the
rear fog lamp switch with the blue lead and the wire to the rear fog lamp with the grey lead of the
wire lane using cutter connectors. For vehicles with two rear fog lamps, the second rear fog lamp's
wire is also to be separated and a connection between the gray wire and the second rear fog lamp
is to be made. (if necessary, extend the wire lane's gray lead).
The vehicle's own rear fog lamp is switched off via the control unit.
rear fog lamp switch
separate
left rear fog lamp
12
Control unit
Disconnect line
blue
disabling
contact
control unit
gray
connection to
the
second rear
fog lamp
green/white or gray/yellow
Turn signal lamps
rear fog lamp switch
separate
right rear fog lamp

Publicité

Table des Matières
loading

Table des Matières