Publicité
Les langues disponibles
Les langues disponibles
Before measurement, refer to the section "Notes for Accurate Measurement" on
the next page.
Normal Measurement
1.
Press the
SET
2.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
3.
Press the
START
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is
normal for the cuff to feel very tight. A
pressure bar indicator is displayed, on the
left edge of the display, during the inflation.
Note: If you wish to stop inflation at any time,
press the
4.
When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained,
the device starts to inflate again automatically.
To avoid re-inflation, see the section
"Measurement with the Desired Systolic
Pressure" on the next page.
5.
When the measurement is complete,
the systolic and diastolic pressure
readings and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
6.
When not recording the measurement
data, press the
7.
Press the
START
After one minute of non-operation, the
device will turn off automatically.
Note: Allow at least three minutes between
measurements on the same person.
All manuals and user guides at all-guides.com
Measurements
button to select a user from 1 to 4.
button.
button again.
START
(heart mark) blinks,
or
button.
button to turn the device off.
English 16
At heart level
Press
All of the display
segments displayed
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
air automatically
START
Publicité
