Angelo Po 10NCP1IA Manuel D'utilisation page 41

Alarm
Electronic circuit board diagnostics
E07
Electronic circuit board diagnostics
E16
Electrical component
E17
compartment has overheated
Electronic circuit board diagnostics
E20
E21 Control panel overtemperature
E22 Basket lifting failure
No mains gas, gas pressure too low
GAS
or fl ame detection failure
The water level in the cooking well
has dropped below the minimum
H2O
level, so the appliance is not
3329640_ut_GB
Causes
tripped
tripped
tripped
heating up.
The appliance's functions are disabled so no
cooking cycles can be carried out.
Contact the after-sales service.
The appliance's functions are disabled so no
cooking cycles can be carried out.
Contact the after-sales service.
The appliance solves the problem on its own.
The appliance's functions are enabled and so
cooking cycles can be carried out.
The appliance's functions are disabled so no
cooking cycles can be carried out.
Contact the after-sales service.
The appliance solves the problem on its own.
The appliance's functions are enabled and so
cooking cycles can be carried out.
The appliance's functions are enabled and so
cooking cycles can be carried out.
Inform the after-sales service.
Contact the after-sales service.
Hold down the reset button for a few seconds
(the button may have to be pressed several
times); if the problem persists inform the after-
sales service
Top up the water level in the cooking well
- 19 -
Remedies
GB
ENGLISH