Replacing The Burner Air Bushing; Replacement Of The Burner Nozzle - Angelo Po 10NCP1IA Manuel D'utilisation

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Undo the screw (B).
3)
Extract the bushing (C) and replace it with
4)
the one suitable for the type of gas in use
(see table at back of manual).
To carry out this operation, proceed as follow.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Unscrew the nozzle (B) and replace it with
3)
the one suitable for the type of gas in use (see
table at back of manual).
B
3329640_inst_GB

REPLACING THE BURNER AIR BUSHING

A

REPLACEMENT OF THE BURNER NOZZLE

Adjust the position of the bushing (C) (see
5)
page 16).
Tighten the screw (B).
6)
Close the hatch (A) when the operation is
7)
complete.
Close the hatch (A) when the operation is
4)
complete.
- 17 -
C
B
A
ENGLISH
GB