Electrical Connection; Conversion Of Gas Supply - Angelo Po 10NCP1IA Manuel D'utilisation

Сuiseur à pâtes
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Important
Those authorised to carry out the connection
operation must have experience acquired
and certifi ed in the specifi c sector, in accord-
ance with current legislation in the appli-
ance's installation country.
The connection must make to the proper
standards and must comply with all the rel-
evant regulations and legislation.
The appliance is supplied with operating vol-
tage 230V/1N 50Hz ( Selector switch allowed
60Hz, see electrical system diagram).
Caution - Warning
Before doing any work, cut off the mains
electricity supply.
Connect the appliance to the mains electricity
supply as follows:
F
E
GB
Caution - Warning
Before doing any work, cut off the mains
electricity supply.
The manufacturer has tested the appliance with
its own mains gas, identifi ed by the sticker ap-
plied to the nameplate.
If the type of gas to be connected is diff erent
from that used for testing, proceed as follows.
Turn off the gas supply tap (A).
1)
3329640_inst_GB

ELECTRICAL CONNECTION

1)
2)
3)
4)
5)
When connecting, take care to connect the
neutral and earth lines.
6)
A

CONVERSION OF GAS SUPPLY

- 12 -
If not already present, install an automatic
circuit-breaker
, with overload cutout and
(A)
diff erential safety breaker close to the applian-
ce.
Open the hatch (B).
Undo the screws (C) to remove the control
panel (D).
Undo the screws (E) to remove the guard (F).
Connect the circuit-breaker (A) to the terminal
board (G) of the appliance as shown in the
diagram and in the electrical system diagram
at the back of the manual.
Use a cable with at least H05RN-F characteri-
stics.
Important
Replace all on completion of the operation.
C
C
C
D
A
B
C
C
ENGLISH

Publicité

Table des Matières

Dépannage

loading

Ce manuel est également adapté pour:

10tcp1ia12ncp1ia12tcp1ia20ncp2ia20tcp2ia

Table des Matières