Angelo Po 10NCP1IA Manuel D'utilisation page 22

Important
Make a daily check that the safety devices are
properly installed and in good working order.
Cautela - Avvertenza
The fl oor, near the appliance, could be slip-
pery.
Important
The necessary connections (water, electricity
and gas) must be set up exclusively by suita-
bly specialised staff , in accordance with local
requirements.
Important
Drain the well completely after use.
Cautela - Avvertenza
Caution - Warning
Never use the appliance with no water in the
well, as this may damage its structure.
Important
Before carrying out any servicing procedure,
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed.
Important
Before starting any cleaning operation, al-
ways turn off the gas supply tap, cut off the
electricity supply using the master switch
and allow the appliance to cool.
Caution - Warning
When using detergents, rubber gloves,
protective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
Caution - Warning
Never use products containing substances
harmful or hazardous for health (solvents,
petroleum spirits, etc.).
Caution - Warning
Before doing any work, cut off the mains
electricity supply.
Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
Important
Before making any type of adjustment, acti-
vate all the safety devices provided and de-
cide whether staff at work and those in the
vicinity should be informed.
Important
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those
in the vicinity should be informed.
Caution - Warning
Do not obstruct the fl ue to avoid the tem-
perature of the combustion components and
products from increasing excessively over
the admissible limits.