Cleaning Instructions; Cleaning The Water Level Sensor Electrodes - Angelo Po 10NCP1IA Manuel D'utilisation

Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding environ-
ment must constantly be kept clean.
Important
Before starting any cleaning operation, al-
ways turn off the gas supply tap, cut off the
electricity supply using the master switch
and allow the appliance to cool.
The precautions which follow are also impor-
tant.
Caution - Warning
When using detergents, rubber gloves, pro-
tective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
– Clean all parts of the appliance with warm
water, food-approved detergents and non-
abrasive materials only.
Proceed as follows.
Raise the electrode holder (A).
1)
GB Caution - Warning
Take care over the connection cable (B).
Clean the electrode holder (A) and the elec-
2)
trodes (C) with a non-abrasive sponge and a
food-approved detergent.
Rinse thoroughly to remove all residues of the
3)
product used and dry.
Rinse the guide tube of the electrode holder
4)
(D) with drinking water.
Caution - Warning
The guide tube of the electrode holder is in
communication with the cooking well. Do not
allow dirt or chemicals to enter the tube.
3329640_ut_GB

CLEANING INSTRUCTIONS

CLEANING THE WATER LEVEL SENSOR ELECTRODES

– Thoroughly clean all parts which come into
direct or indirect contact with foods and all
surrounding areas.
– After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
Caution - Warning
Never use products containing substances
harmful or hazardous for health (solvents,
petroleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on
external parts.
– Take special care not to damage stainless
steel surfaces. In particular, avoid the use of
corrosive products and do not use abrasive
materials or sharp tools.
– Remove food residues immediately before
they set.
– Remove the limescale deposits which may
form on some of the appliance's surfaces.
C
B
Clean the cooking well and empty it to remo-
5)
ve any cleaning residues (see page15).
Replace the electrode holder (A).
6)
- 16 -
A
D
ENGLISH