Publicité
- Unfasten hook and loop closures on the seat back and bottom.
- Remove the shoulder belts by tilting the clasp and pushing them through
the board. Picture 32
- Remove the reinforcement boards from the back and the seat through the
opening.
- Détachez les crochets et les boucles au dos et au bas du siège.
- Enlevez les épaulières en inclinant l'agrafe et en les poussant par les
renforts. Illustration 32
- Enlevez les renforts du dossier et du siège en les passant par les
ouvertures.
Replace Seat Cover after Washing:
- Place back the reinforcing boards, making sure the belts are fastened
properly.
- Fasten the elastic straps to the metal frame.
- Zip up the zippers.
- Never use the seat without the reinforcement boards or seat belt.
Pour remettre la housse du siège après l'avoir lavée:
- Replacez les renforts, en vous assurant que les ceintures sont attachées
correctement.
- Attachez les courroies élastiques au châssis en métal.
- Remontez les fermetures-éclairs.
- Ne jamais utiliser le siège sans les renforts ou la ceinture de sécurité.
Wheel and Tire Maintenance:
- The tires can be inflated to a maximum pressure of 28 psi (193 kPa). The
tires are equipped with air valves and can be inflated using the pump
supplied or a bicycle pump with adapter.
- Tire Pump Use: Remove hose from inside pump handle. Reverse hose
and thread into end of tire pump. Thread hose onto tire valve stem. Pull
and push tire pump handle until tire fills with air and pressure is within
the tire manufacturer's recommendation. Store hose inside pump handle
and keep pump in pouch at rear of basket when not in use.
- If the inner tube has a puncture, you can repair it as you would a bicycle
tire or have it repaired at a bicycle repair shop.
- Always deflate the tires when taking the Freestyle 4 on an aircraft, as the
tires could burst due to pressure difference.
- The stroller may be prone to rusting/tarnishing if used on a beach. Riding
through seawater is therefore not advised. Clean the wheels thoroughly
after visiting the beach.
- Clean the wheels and axles often and remove any sand or dirt before
assembling them.
- The tires may leave behind black marks on some surfaces (particularly
smooth floors like parquet, laminate and linoleum).
Entretien des roues et des pneus:
- Les pneus peuvent être gonflés à une pression maximum de 193 kPa
(28 psi). Les pneus sont équipés de soupapes à air et peuvent être
16
gonflés avec la pompe fournie ou une pompe à bicyclette avec un
adaptateur.
32
Publicité
