shark RACE-R PRO GP 06 Manuel D'utilisation page 6

WARNING! Never use the loop as
the sole means for closing the chin
strap. To ensure adequate tightening,
the chin strap must be inserted into the
double-D buckles in strict accordance
with the instructions. Any misuse of
the chin strap may result in your helmet
coming off during an accident, thereby
leaving your head exposed without any
protection. Try pulling on the chin strap
with your fingers. If the strap loosens
even to the slightest extent, you haven't
DOUBLE-D RING
1. Slide the longest part of the chin strap
through the two rings, while verifying that
the comfort pad is correctly positioned
between the strap and your neck (see
Figure A).
2. Form a loop with the end of the chin
strap around the outer ring and reinsert it
into the inner ring (see Figure B).
C
6
properly closed
the double-D buckles. If so, repeat
the steps described
Never ride with the chin strap open,
inadequately closed or poorly positioned.
Even if the cheek
impression that the helmet is providing
secure support, it would still come off
during an accident, thus leaving your
head exposed without any protection.
Should you have any doubts concerning
the helmet closing system, don't use
the helmet. Ask your retailer for advice.
3. Pull on the strap end until the chin strap
is taut. The chin strap must be positioned
against the neck and not under the chin.
It must be as tight as possible without
causing pain or obstructing breathing (see
Figure C).
4. Clip the pressure on the free end of the
strap to prevent any flapping of the strap in
the wind (see Figure D).
B
the chin strap
opposite.
pads give the
D
in