shark RACE-R PRO GP 06 Manuel D'utilisation page 12

ANTI-FOG MASK
Large mask (winter/racing)
ASSEMBLY: To use the racing anti-fog mask,
remove the small mask. Remove the cheek
pieces. Fix the upper part to the 3 mask
support studs (A). Place a tube in its housing
(B). Position the mask attachment around the
pressure housing (B). Clip the cheek piece to
lock this attachment. Begin the operation
again on the other side. 2 air extractors
ensure that the air is completely renewed,
even in the most extreme conditions.
DISASSEMBLY: Remove the cheek pieces.
Remove the tubes from their housings.
Detach the upper part from the 3 studs
and withdraw the mask. Replace the cheek
pieces.
WARNING! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal or
replacement of the interior padding, DO NOT
USE YOUR HELMET. Contact your retailer
for assistance or advice. NEVER use your
helmet with any part of the interior padding
removed. The helmet will not protect you in
an accident.
FILTRE ANTI-POLLUTION
An anti pollution filter, removable and with
3 positions, enables the manage went of
the air flow.
• Position 0 : maximum air flow (without
filter)
• Position 1: air flow filtered
• Position 2 : air flow toward the mouth
closed (air directed only toward the visor)
It is recommended to regularly change your
filter especially if you ride in a polluted
environment. The anti-pollution filters spares
are available at your dealer.
12
A
B
0
1
2
C