CLEANING THE INTERIOR
The interior textile parts are
washable; it is important to strictly
follow the instructions below to
avoid damaging them:
The cheek pads and head section
must be hand washed in warm,
soapy water (about 30°). Do not use
aggressive detergents but either a
product for delicate materials in
low dilution or household soap.
It is essential to dry textile and
foam parts completely before
reinstalling them in the helmet.
They must be air dried at room
temperature. Never use a clothes
dryer or other heat source. Never
iron textile parts.
For parts with a leather appearance
or textiles attached to safety
elements, use a slightly damp
sponge or cloth and household
soap and rinse with clean water.
Do not allow too much water to
come into contact with polystyrene
parts.
You must insure that all interior
parts are perfectly dry before using
the helmet.
WARNING!
interior
compromise the fit of your
helmet on your head and could
allow the helmet to come off your
head in an accident, resulting in a
head injury or death.
10
Damaged
padding
will
THE TEXTILE PARTS
The
textile
and
providing comfort to the Race-R
Pro GP 06 make it easy for you
to appreciate the performance of
your helmet to the full.
The parts in contact with the
skin are made in a fabric that is
guaranteed to feel pleasant, to
absorb perspiration well and to
resist wear satisfactorily.
We treat surfaces to limit the risk
of mould and bacteria.
WARNING! Although they
are selected for their quality
of resistance and satisfactory wear,
all the comfort padding is subject to
normal wear and tear. The rate of
wear and tear will depend on use,
care and maintenance, the length
of use and the degree of acidity of
your perspiration. Wear and tear of
the comfort padding will eventually
change the fit of your helmet on
your head. If that occurs, you must
immediately replace the helmet or
padding. See your retailer for advice.
WARNING! Each time you
put on your helmet, check
the fit as discussed in "Choose your
size".
foam
parts