shark RACE-R PRO GP 06 Manuel D'utilisation page 2

Thank you for choosing a Race-R Pro GP 06
helmet. The Race-R Pro GP 06 is a top-quality
helmet that is ideal for use in urban and extra
urban areas. For the Race-R Pro GP 06, SHARK
has invested all of its designing experience
in safe headgear for riding two-wheeled
motorised vehicles. The helmet complies with
international standards but does not purport to
guarantee total protection in all circumstances.
Make sure you carefully read all of the following
recommendations before using the helmet.
Just because you are wearing a helmet does
not mean you should neglect driving carefully.
Standard: This Race-R Pro GP 06 SHARK
helmet has been approved and conforms to the
UNECE R 22/06 standard. It therefore meets
the requirements imposed on all the countries
that recognise this standard in their territory.
WARNINGS AND INSTRUCTIONS
1 . Always ride with care. Even though
this helmet meets or exceeds many of the
world's most demanding standards for helmet
production, no helmet can protect the wearer
from all foreseeable high or low speed impacts.
All safety equipment have limits, and you
could still sustain a head injury in an accident
even if you are wearing a helmet. However,
for maximum protection against death or
permanent impairment from a head injury,
the helmet must fit firmly on your head and
the chinstrap must be securely fastened as
described in this manual.
2. The helmet is designed to absorb impact
by partial destruction of the shell and/
or liner. This damage may not be visible to
you. Therefore, if your helmet is subjected to
any impact, even if it is only dropped to the
ground, the helmet should be returned for
inspection or replaced and destroyed even if
it is apparently undamaged. If you have any
doubts, and you are not sure whether this rule
applies, consult your dealer before you use
your helmet again.
3. A helmet, like all products, may wear out
over time depending on the conditions of use.
Please check your helmet every time you use
it for evidence of damage or wear. The helmet
should always fit snugly all around your head.
If it is not snug, it has become too big for you
and should be replaced. Never wear a damaged
helmet. Even if the helmet does not show any
evidence of damage or wear, we recommended
the helmet to be replaced five years after it is
first purchased.
4. Make no modifications whatsoever to your
helmet. Never drill or cut any component of
the helmet. Modifications can significantly
weaken your helmet, thereby eliminating its
2
ability to protect you from an impact.
5. Handle your helmet carefully. Never sit on
it or drop it to the ground. Never ride with
the helmet hanging from any part of your
motorcycle.
6. Never use petroleum or petroleum products,
chemicals or any other solvents to clean the
helmet, shell or visor. In addition, never expose
your helmet to the fumes of these solvents (for
example by leaving it on top of the fuel tank
cap on your motorcycle). Your helmet could be
seriously damaged by these agents, without
this damage being visible to you, thereby
eliminating its ability to protect you. Use only
mild soap, warm water, and a soft cloth to wipe
your helmet and visor clean.
7. Never apply any paint, stickers or adhesive
tape to any part of your shell or visor. They
could significantly weaken your helmet,
without this damage being visible to you,
thereby eliminating the helmet's ability to
protect you.
8 . You will experience some reduction in
hearing, peripheral vision and head movements
while you are wearing your helmet. Please ride
accordingly.
9. Dry your helmet at room temperature. Never
subject it to heat in excess of 160°F/70°C,
which can occur if your helmet is stored in the
passenger compartment or trunk of a car.
10. If you ever have any comments or
questions about this helmet, please contact
SHARK or your nearest dealer.
No warranty or representation is made as
to this product's ability to protect the user
from all foreseeable high or low speed impacts
or from any injury or death; The user of this
helmet recognizes and agrees that there are
risks inherent in motorcycle riding, including
but not limited to the risk that your helmet
cannot protect against all foreseeable high
or low speed impacts. By his/her purchase
and use of this helmet, the user expressly,
voluntarily and knowingly accepts and
assumes these risks and agrees to hold SHARK
harmless to the fullest extent permitted by law
against any resulting damages.