CASO DESIGN MyVac 20 Mode D'emploi page 37

Attention
► Switch the vacuum system off prior to cleaning it and unplug the plug from the wall
power outlet.
► The sealing strip is hot after it is used. There is a danger of burns! Wait until the device
has cooled down.
► Clean the device after use as soon as it has cooled down. Extended waiting
unnecessarily complicates cleaning and can make it impossible in extreme cases.
Excessive accumulations of dirt can even damage the device under certain
circumstances.
► Never immerse the unit into water or the dishwasher.
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
16.2 Cleaning
 External and Inner Cover Plate
 Take off the external and inner cover plates by a slight turn and clean them by using a
mild, non galling soap solution.
 Boxes, Covers, Bottle Cap and Accessories
 Wash the accessories with warm rinse water and let it carefully dry afterwards, before
you use it again.
 Preservation bags
 Washing the bagging material in warm water with a mild dishwashing soap, then rinse
the bags well and allow drying thoroughly before reusing
Attention
► Bags used to store raw meats, fish or greasy foods can't be reused.
Please note
► The airproof loop of sponge should be dried thoroughly prior to reassembling.
► When re-assembling, be careful to prevent any damage and assembles as original
position to ensure no vacuum leaking.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
caso Vakuumierer MyVac 20
 Dry thoroughly before using again.
.
37