Diamond D115-EK Mode D'emploi page 12

Page. 12
6
5
Faults are easily seen from the messages on the screen (4 and 5) and from any interruption of the
operations in progress only in cases (1 and 3) listed below
WARNING! Turning the machine off and then on again resets the warning, which will appear again if
the problem has not been resolved
DISPLAY ON THE MESSAGE
Boiler (6)
Tank (5)
Boiler (6)
Tank (5)
Boiler (6)
Tank (5)
Boiler (6)
Tank (5)
Boiler (6)
Tank (5)
6
5
1. TANK NOT FILLED OR OVERFILLED
if ≥10 min have elapsed, correct level of water has not
been reached in the tank
2. BOILER PROBE FAILURE
if the probe is not connected correctly or damaged
if the probe is short circuited or damaged
3. OVERTEMPERATURE
excessive boiler and tank temperature
Tank and safety boiler thermostat trip and draft safety
microswitch
3.3 SAFETY FEATURES
The board can
breakdowns
.
PROBLEM:
GB
recognize various