Diamond D115-EK Mode D'emploi page 10

Page. 10
a) Check the level in the wash tank making sure that
when the solenoid valve closes the water is 1-2 cm
below the overflow level.
b) Check that the wash tank temperature is 55 - 60°C by looking at
the thermometer on the control panel.
Check that the boiler temperature is between 85 - 90°C by looking
at the thermometer on the control panel.
c) Check the working order of the automatic surface active agent
dispenser which will, however,
installs the machine
d) Check the working order of the rinse economiser. It must start to
distribute hot water rinse at system pressure when a rack arrives under
the jets and stop when the rack comes out.
It is recommended that the water in the boiler be cold for this
step.
e) Check the operation of the machine limit switch. It must stop motor
and pump operation when a rack reaches the end of the table.
Operation must start again when the rack is removed.
f) Check the rotation direction of the pumps and motors, if they rotate
in the opposite direction invert the two phases of the power supply
cable.
NOTE:
Check the rotation of the sledge. The reduction gearbox must
rotate clockwise (as in the figure), otherwise, invert the phase in
the power cable.
WARNING: If the sledge is rotating in the direction opposite to
that shown, the safety feature is disabled!
The non-observance of such inspections will result in the
invalidation of the warranty.
1- WASHING DIRECTION SELECTION
ON ⇒ Machine with drum opening on left
OFF ⇒ Machine with drum opening on right
2- AUTOTIMER SELECTIONS
ON ⇒ Machine starts when drum is inserted.
OFF ⇒ Machine starts manually.
2.9
be started by the technician who
2.10
GB
CHECKS
SETTINGS