R&G ECS0004BK Instructions De Montage

FITTING INSTRUCTIONS FOR ECS0004BK ENGINE CASE SLIDERS
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
Offside (Right Hand Side as you sit on the bike)
•
Remove the four bolts that hold the clutch housing to engine. DO NOT REMOVE THE
HOUSING.
•
Place the R&G protector over the top and fix in place, using four of the M6x30 button head bolts
supplied, to a torque setting of 10Nm.
Nearside
•
Repeat as above for the nearside.
BMW K1200S K1200R K1300S K1300R