R&G EH0063BK Instructions

FITTING INSTRUCTIONS FOR EH0063BK/ EXHAUST HANGER
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!

Remove OEM rear foot pegs/exhaust hanger.

Place two of the M8 button head bolts from kit through the two top holes in the R&G hanger.

Offer up to bike as shown above and engage threads (do not tighten yet).

Place the 8mm washer onto the remaining M8 button head bolt from kit and position through
exhaust mount as shown.

Place the original nut onto exposed end of bolt and tighten all bolts evenly.

Please ensure when the motorcycle is being used that no parts are in such a position that they may
collide/damage other bike parts (this is particularly important if using after-market cans or exhaust
systems).
Please note that it is your responsibility to ensure that no part of the exhaust
hanger or exhaust assembly fouls or comes into contact with other parts of the
machine. Do not ride the motorcycle until this aspect has been verified and you
have compressed the rear suspension (if appropriate to the design of the
motorcycle) to test this thoroughly.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
YAMAHA YZF-R25/R3 2014-
ISSUE 1 13/11/2014 (NSY)
R&G Racing
www.rg-racing.com
- 1 -
Email: info@rg-racing.com