Table des Matières
Publicité
Page 6 of 9
•
Slide the black inner fairing panel (previously secured with the bolts in pictures 8
and 9) forwards until the clips disengage. To release the clip at the front, pull the
black cover marked with the red arrow in picture 9 in the direction indicated by
the arrow while simultaneously sliding the inner fairing panel forward.
•
Remove the 2 bolts arrowed in picture 11 from the left side.
•
Remove the bolt arrowed in picture 12 from the left side.
•
Pull the main fairing away from the radiator shroud as shown in picture 13 and
away from the nose as shown in picture 14.
•
Remove the main fairing, to do this pull gently on the edge of the fairing by the
fuel tank to release the Velcro and plastic locator indicated in picture 15.
•
To fit the R&G engine case slider remove the three M6 engine case bolts in the
positions arrowed in picture 16.
•
Offer up the R&G engine case slider (item 1) to the engine and secure in position
using the three M6 bolts and washers (items 2 and 3) as shown in the top
picture.
•
Refit all fairings as original
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G
may make design changes which do not diminish their performance or visual appeal and supplying them in
such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in R&G's order or confirmation and the
Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular
purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care
and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any
defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall
not be liable if the Products have been modified or used or maintained otherwise than in accordance with
R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal
injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the
amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the
Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned
direct to us if they were purchased direct from us (customer must prove if necessary).
returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G. All returns are
subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at
time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products,
unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 2
27/05/2020
CONSUMER NOTICE
R&G RETURNS POLICY (NON-FAULTY GOODS)
R&G
(NSY)
www.rg-racing.com
Email:
info@rg-racing.com
ECS0148
Otherwise to be
Publicité
Table des Matières
