Bitzer CT-120-2 Traduction De La Notice D'origine page 76

01.10.2018
Abbr Component
B2 Control unit (cooling demand) or command for
compressor start (release signal from the sys-
tem controller) or controller On/Off
B6 High pressure transmitter
B7 Low pressure transmitter
F1 Main fuse
F2 Compressor fuse
F3 Control circuit fuse
F4 Oil heater fuse
F5 High-pressure switch
F6 Low pressure switch
F7 Switching on delay "ECO"
F8 Oil level switch (minimum oil level), option
F9 Control thermostat "LI"
F10 Control thermostat for additional oil injection
F13 Thermal overload relay "motor" (1st part wind-
ing and star-delta)
F14 Thermal overload relay "motor" PW2
F17 Control transformer fuse
F21 Fuse of the heating element in the terminal
box
F30 Fuse of compressor protection device
H1 Signal lamp "fault SE-i1"
H2 Signal lamp "pause time"
K1 Contactor "1st part winding" (PW) or main
contactor (star-delta)
K2 Contactor "2nd part winding" (PW) or delta
contactor (star-delta)
K3 Star contactor (star-delta)
K2T Time relay "pause time" 300 s
K3T Time relay "part winding" 0.5 s or "star-delta"
1 s (CS.95: 1.5 .. 2 s)
K5T Time interval relay "CR4" flashing function
on / off 10 s
M1 Compressor
Q1 Main switch
R1 Oil heater
R2 Oil temperature sensor (CS.: PTC ② or NTC
➂)
R3-8 PTC sensor in motor (CS.)
R9 Heating element for terminal box
R10 Optional temperature sensor
S1 Control switch (on/off)
S2 Fault reset "SE-i1"
CT-120-2 // PDF Download 76