Automatic Operation - Venta LW15 COMFORT Plus Mode D'emploi

Display
6 Auto
Function

Automatic operation

ON: AUTO in the display flashes continuously and device
automatically regulates the rotational speed depending on
the humidity in the room.
i
When switching on AUTO, the desired humidity (50 % pre-set)
flashes twice and then will show the measured humidity in the room
in the HUMIDITY display 1.
If the pre-set humidity is exceeded by more than 5 %, the fan will

switch off after approx. 60 seconds and no rotational speed will
appear in speed display 2. No air humidification/air purification will
take place.
OFF: AUTO in the display is lit continuously, and the device
runs at the set rotational speed 1 - 3.
Set desired humidity 30 – 70 %:
Hold AUTO-button for 3 seconds. The HUMIDITY 1 dis-
play will flash continuously. Set the desired humidity (in 5 %
increments) using the - or + buttons 3. Hold AUTO-button
for 3 seconds again until the flashing in display HUMIDITY 1
and the humidity measured in the room is shown again.
Venta Comfort
Plus
EN 19