Overview; Putting Into Operation - Venta LP60 Mode D'emploi

OVERVIEW

1 Display
On/off switch
2
3 Fragrance/filter compartment
Fragrance holder
4
5 Pre-filter
Premium VENTAcel H13 Filter
6

PUTTING INTO OPERATION

01 06
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Open the fragrance/filter compartment
3+7, remove the pre-filter 5+9, the VENTAcel filter 6+10 and unpack them.
Re-insert the VENTAcel filter 6+10 and pre-filter 5+9.
02
Close the fragrance/filter compartment 3+7.
03
Inserting the fragrance: Open the fragrance/filter compartment 3 or 7.
04
Twist open the fragrance cap and insert it into the fragrance holder 4/8.
Insert up to three fragrances into the fragrance holder 4+8. Close the
fragrance/filter compartment 3/7.
05 The display 1 can be adjusted to three positions.
06 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 11
Attention! The coupling of the mains cable must be plugged firmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 12.
7 Fragrance/filter compartment
Fragrance holder
8
9 Pre-filter
10 Premium VENTAcel H13 Filter
11 Cable compartment
12 Remote control
ON/OFF
Set fan stage
Venta LP60 GB 4